Dodge 2000 Durango Owner's Manual download pdf (Page 8)

Lit. No. 63617

September 13, 2002

SOLENOID CONTROL INSTALLATION

Solenoid Control

Control Bracket

Cable Clamp

#8-32 x 3/8"

Thread Cutting

Tapping Screw

Dash Bracket Ho

See Step 2

Dash Bracket Ho

See Step 1

#8-32 x 3/8" Hex Head

Thread Cutting Screw

#8 Spring Lock Washer

Dash Bracket

10 x 1" Sheet

etal Screws

10 Lock Washers

#8 x 5/8" Hex Head

Tapping Screws

SOLENOID CONTROL - FLOOR MOUNTED

INSTALLATION INSTRUCTIONS

1. Align dash bracket hole shown in diagram to end

hole of control bracket.

NOTE: Top flange of control bracket may be

reversed in dash bracket from position shown

in diagram. Attach with one #8 x 3/8" hex head

thread cutting screw and lock washer on each

side.

2. Use top holes in dash bracket (see diagram) as a

template to drill a 9/64" hole in each side of control

bracket. Secure dash bracket to control bracket

with a second screw and lock washer in each side.

3. Secure solenoid control to control bracket with two

#8 x 5/8" hex head tapping screws.

4. Move seat forward. Locate control and bracket

assembly on floor tunnel so that it does not

interfere with the operation of vehicle controls.

Mark this location.

5. Remove control bracket from dash bracket.

6. Place dash bracket in marked location. Use dash

bracket as a template to drill four 1/8’’ holes in

tunnel.

NOTE: Before drilling any holes, check both

sides of the material for any wires, fuel lines,

fuel tanks, etc. that may be damaged by drilling.

7. Secure dash bracket to tunnel with four #10 x 1"

sheet metal screws and lock washers.

8. Reassemble control bracket to dash bracket. Bend

top flange of control bracket to desired position.

9. Secure harness to control bracket with cable clamp

and one #8 x 3/8" hex head thread cutting screw.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

Dodge 2000 Durango Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Cars Dodge 2000 Durango