Dodge 2000 Durango Owner's Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
13
Lit. No. 63617
September 13, 2002
OPERATIONAL TESTS AND ADJUSTMENTS
VEHICLE LIGHTING CHECK
1. Check the operation of vehicle and plow lights with
plow mounted to vehicle and all harnesses
connected.
Turn signals and parking lamps
Parking lamps ON
Both vehicle and plow parking lamps should be
on at the same time.
Right turn signal ON
Both vehicle and plow right turn signal lamps
should flash at the same time.
Left turn signal ON
Both vehicle and plow left turn signal lamps
should flash at the same time.
Headlamps
Move vehicle headlamp switch to the ON position.
Connecting and disconnecting the 9-pin or 12-pin
plow plug from the vehicle harness connector should
switch between vehicle and plow headlamps as
follows:
9-pin or 12-pin plow plug DISCONNECTED
Vehicle headlamps should be on.
Plow headlamps should be off.
9-pin or 12-pin plow plug CONNECTED
Plow headlamps should be on.
Vehicle headlamps should be off.
Dimmer switch should dim whichever headlamps are
operating. The high beam indicator on the dash
should light when either set of headlamps is on high
beam.
Solenoid Control or CabCommand Control
9-pin or 12-pin vehicle harness revision 10 and later
or 9-pin or 12-pin vehicle harnesses - earlier
revisions modified for CabCommand Control
The control indicator light should light whenever
the control ON/OFF switch and the ignition
(key) switches are both turned ON. The plow
plugs do not need to be connected to the
vehicle harness connectors.
2. Connect plow plug to vehicle harness connector.
Raise plow and aim plow headlamps according to
SAE J599 Lighting Inspection Code (See Service
Bulletin SP 608) and any state or local
regulations.
3. Check aim of vehicle headlamps with plow removed.
4. When plow is removed from the vehicle, install plug
covers on vehicle harness connectors and insert the
plow plugs into the boot on the hydraulic unit.
NOTE: After using the snowplow for 5-10 hours,
retorque all mount assembly fasteners.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments