Dodge 2000 Durango Owner's Manual download pdf (Page 6)

Lit. No. 63617

September 13, 2002

MOUNT INSTALLATION

FOG LAMPS

1. Disconnect fog lamp harness from bumper lamps

if equipped.

MOUNT FRAME

1. Open vehicle hood and remove four bumper bolts

from the top of bumper bracket. Remove two outer

bumper bracket bolts from side of frame. Remove

bumper with brackets. Cut off rubber portion of air

deflector attached to air dam and discard.

2. Remove snap fasteners and fan air deflector.

3. Remove two bumper bracket nuts at front of frame

horns. Clamp bumper bracket to frame and use a

hammer and chisel under the head to drive out

M12 serrated button head screw. Remove clamp.

Repeat for other side. Retain parts for reinstallation

if mount is removed from vehicle.

4. Place mount frame onto vehicle frame horns. Align

slots in mount with slots in frame and holes in

bumper brackets. Fasten with 1/2"-13 x 1-1/2"

bolts, lock nuts, and washers. (Place nuts and

washers inside frame toward slots and outside of

vehicle.) Angle piece welded to side of spreader

must be against bottom of frame.

Mount Frame

1/2" x 1-1/2" Bolt

Must be against

bottom of frame

1/2" x 1-1/4" Bolt

1/2" Dia. Drill

1/2" x 1-1/2

U-Bolt

Thrust Frame

1/2" x 1-1/2" Bolt

9-1/2" to 10-1/2"

Plow attached and

resting on ground

Road

Link Arm

Lug

Coupling Lug

ink Arm

Notch

3/4" x 3-1/4"

Rivet

As Viewed From Driver Side

Typical Bumper

racket End View

Lengthen Sl

1/4" to Insid

Chamfered side of

link arm holes

towards the center

of the vehicle

See Page 12

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments

Dodge 2000 Durango Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Cars Dodge 2000 Durango