Dodge Challenger SRT8 2013 User's Guide download pdf (Page 74)

Programming A Non-Rolling Code

• For programming Garage Door Openers manufactured before 1995.

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you

wish to program while keeping the HomeLink® indicator light in view.

3. Simultaneously press and hold both the HomeLink® button you want to program and the

hand-held transmitter button.

4. Continue to hold buttons until the EVIC display changes from “CHANNEL #TRAINING” to

“CHANNEL # TRAINED”, then release both buttons.

5. Press and hold the programmed HomeLink® button and observe the indicator light.

NOTE:

• If the EVIC displays “DID NOT TRAIN” repeat from Step 2.

• To program the two remaining HomeLink® buttons, repeat each step for each remaining

button. DO NOT erase the channels.

Using HomeLink®

• To operate, press and release the programmed HomeLink® button. Activation will now

occur for the programmed device (i.e., garage door opener, gate operator, security

system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the

device may also be used at any time.

WARNING!

• Your motorized door or gate will open and close while you are programming the

universal transceiver. Do not program the transceiver if people or pets are in the path

of the door or gate.

• Do not run your vehicle in a closed garage or confined area while programming the

transceiver. Exhaust gas from your vehicle contains Carbon Monoxide (CO) which is

odorless and colorless. Carbon Monoxide is poisonous when inhaled and can cause

you and others to be severely injured or killed.

ELECTRONICS

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 139 140

No comments

Dodge Challenger SRT8 2013 User's Guide Page 74