Dodge Challenger SRT8 2013 User's Guide Page 72

  • Download
  • Add to my manuals
  • Print
  • Page
    / 140
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 71
Sound Horn With Lock
To turn the horn chirp on or off when the doors are locked:
Press the LOCK button for at least 4 seconds, but no longer than 10 seconds. Then, press
the PANIC button while still holding the LOCK button.
Release both buttons at the same time.
Flashing Lights With Lock
The turn signal lights flashing, when the doors are locked or unlocked, feature can be
turned on or off. To turn this feature on or off:
Press and hold the UNLOCK button for at least 4 seconds, but no longer than 10 seconds.
Then, press and hold the LOCK button while still holding the UNLOCK button.
Release both buttons at the same time.
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
HomeLink® replaces up to three hand-held transmitters that operate devices such as garage
door openers, motorized gates, lighting or home security systems. The HomeLink® unit is
powered by your vehicles 12 Volt battery.
The HomeLink® buttons that are located in the overhead console or sunvisor designate
the three different HomeLink® channels.
The HomeLink® indicator is located above the center button.
Before You Begin Programming
HomeLink®
Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accu-
rate transmission of the radio-frequency
signal it is recommended that a new bat-
tery be placed in the hand-held transmitter
of the device that is being programmed to
the HomeLink® system.
Erase all channels before you begin pro-
gramming. To erase the channels, place the ignition switch into the ON/RUN position,
then press and hold the two outside HomeLink® buttons (I and III) for up 20 seconds.
The Electronic Vehicle Information Center (EVIC) will display “CLEARING CHANNELS”.
Release the buttons when the EVIC displays “CHANNELS CLEARED”.
NOTE:
Erasing all channels should only be performed when programming HomeLink® for the
first time. Do not erase channels when programming additional buttons.
If you have any problems, or require assistance, please call toll-free 1–800–355– 3515 or,
on the Internet at www.HomeLink.com for information or assistance.
ELECTRONICS
70
Page view 71
1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 139 140

Comments to this Manuals

No comments