Dodge 2012 Ram Truck Gas 3500 Owner's Manual download pdf (Page 72)

• If you have any problems, or require assistance, please call toll-free

1–800–355–3515 or, on the Internet at www.HomeLink.com for information or

assistance.

Programming A Rolling Code

• For programming Garage Door Openers that were manufactured after 1995.

These Garage Door Openers can be identified by the “LEARN” or “TRAIN”

button located where the hanging antenna is attached to the Garage Door

Opener. It is NOT the button that is normally used to open and close the door.

The name and color of the button may vary by manufacturer.

• Place the ignition switch into the ON/RUN position.

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink

button you wish to program while keeping the HomeLink

indicator light in

view.

• Simultaneously press and hold both the HomeLink

button you want to

program and the hand-held transmitter button.

• Continue to hold both buttons and observe the indicator light. The Homelink

indicator will flash slowly and then rapidly after Homelink

has received the

frequency signal from the hand-held transmitter. Release both buttons after

the indicator light changes from slow to rapid.

• At the garage door opener motor (in the garage), locate the “LEARN” or

“TRAINING” button. This can usually be found where the hanging antenna wire

is attached to the garage door opener motor. Firmly press and release the

“LEARN” or “TRAINING” button.

NOTE: You have 30 seconds in which to initiate the next step after the LEARN

button has been pressed.

• Return to the vehicle and press the programmed HomeLink

button twice

(holding the button for two seconds each time). If the device is plugged in and

activates, programming is complete.

NOTE: If the device does not activate, press the button a third time (for two

seconds) to complete the training.

• To program the remaining two HomeLink

buttons, repeat each step for each

remaining button. DO NOT erase the channels.

Programming A Non-Rolling Code

• For programming Garage Door Openers manufactured before 1995.

• Turn the ignition switch to the ON/RUN position.

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink

button you wish to program while keeping the HomeLink

indicator light in

view.

• Simultaneously press and hold both the HomeLink

button you want to

program and the hand-held transmitter button.

ELECTRONICS

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 155 156

Comments to this Manuals

No comments

Dodge 2012 Ram Truck Gas 3500 Owner's Manual Page 72

Comments to this Manuals

Related products and manuals for Cars Dodge 2012 Ram Truck Gas 3500