Equipped with AEM® Dryow™ FilterNo Oil Required!INSTALLATION INSTRUCTIONSPART NUMBER: 21-429DS (Plastic Intake Tube) AEM Induction Systems 1 (800)
10t. Install the PCV hose on the nipple on the inlet tube and secure with the 1” hose clamp.u. Connect the other end of the PCV hose to the nipple on
11z. Install the assembly from the previous step on to the inlet tube through the inside of the air box and tighten down the clamp.aa. Install the air
12af. Use the button head M6 allen bolts to secure the lid at the 4 locations.ag. Re-install engine cover removed in step 2h.ah. Re-install charge pip
134. Reassemble Vehicle a. Position the inlet pipes for the best tment. Be sure that the pipes or any other components do not contact any part o
14AEM Air Intake System Warranty PolicyAEM® warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty
2 Description Qty. Part NumberPARTS LISTA Element Parts Kit 6.00 X 5” Reg/Top Dry 1 21-209EDKB 1/2” Bnd. Hose Clamp, 4.125-7.00” 1 94104C 1/2’ Bnd.
3KIT DIAGRAMABCDEFIJJKAFLMRONUVWXRPTQGHGSAAABZYADADADADACAEAEAEAE
41. Preparing Vehicle a. Make sure vehicle is parked on level surface. b. Set parking brake. c. If engine has run in the past two hours, let it co
5e. Loosen hose clamp securing the charge pipe to the coupler on the intercooler.f. Loosen hose clamp securing the charge pipe to the coupler above th
6k. Loosen hose clamp securing the factory inlet tube to the air box assembly. Disconnect the inlet tube from the air box.l. Remove factory air box as
73. Installation of AEM® intake system. a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until i
8h. Bolt the inlet tube bracket to the inlet tube and secure with a socket head M6 screw and M6 x 12 O.D. washer.i. Install the inlet tube. Start by
9n. Peel the backing from the adhesive neoprene sheets and apply them to the air box.o. With both neoprene sheets applied, the front of the air box sh
Comments to this Manuals