Dodge 2012 Caliber Owner's Manual Page 448

  • Download
  • Add to my manuals
  • Print
  • Page
    / 502
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 447
BULB REPLACEMENT
Front Headlamps, Parking, and Turn Signal
Lamps
NOTE: The headlamp bulb can be accessed from under
the hood without the removal of the inner fender well. It
will be necessary to remove the inner fender well to
service the park/turn signal bulb that is located toward
the outboard side of the head lamp unit.
1. Disconnect and isolate the negative battery cable.
2. Working in the appropriate wheel well, loosen the
front of the splash shield, but do not fully remove it.
3. Looking up through the front wheel well, locate the
bulb which needs replacing. The headlamp bulb is the
inboard bulb and the park/turn signal bulb is the out-
board bulb.
4. Disconnect the bulb electrical connector.
5. Grasp the bulb, twist 1/4 turn counterclockwise and
pull straight out of front lamp unit.
Fog Lamps
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
1. Disconnect and isolate the negative battery cable.
2. Remove the front wheel and tire on the same side of
the vehicle as the fog lamp being serviced. Refer to
“Jacking and Tire Changing” in “What To Do In Emer-
gencies” for further information.
3. Remove the three screws that secure the outboard side
of the front wheel house splash shield to the front fascia.
446 MAINTAINING YOUR VEHICLE
Page view 447
1 2 ... 443 444 445 446 447 448 449 450 451 452 453 ... 501 502

Comments to this Manuals

No comments