Dodge 2012 Caliber Owner's Manual download pdf (Page 164)

100

101

To Set A Desired Speed

Turn the Electronic Speed Control ON. When the vehicle

has reached the desired speed, press down on the Elec-

tronic Speed Control lever and release. Release the accel-

erator and the vehicle will operate at the selected speed.

NOTE: The vehicle should be traveling at a steady

speed and on level ground before pressing the SET lever.

To Deactivate

A soft tap on the brake pedal, pulling the Electronic

Speed Control lever toward you CANCEL, normal brak-

ing or pressing the clutch pedal while slowing the vehicle

will deactivate Electronic Speed Control without erasing

the set speed memory. Pressing the ON/OFF button or

turning the ignition switch OFF erases the set speed

memory.

To Resume Speed

To resume a previously set speed, push the RESUME

ACCEL lever up and release. Resume can be used at any

speed above 20 mph (32 km/h).

To Vary The Speed Setting

When the Electronic Speed Control is set, you can in-

crease speed by pushing up and holding the RESUME

ACCEL lever. If the lever is continually held in the

RESUME ACCEL position, the set speed will continue to

increase until the lever is released, then the new set speed

will be established.

Tapping the RESUME ACCEL lever once will result in a

1 mph (2 km/h) increase in set speed. Each subsequent

tap of the lever results in an increase of 1 mph (2 km/h).

To decrease speed while the Electronic Speed Control is

set, push down and hold the SET DECEL lever. If the

lever is continually held in the SET DECEL position, the

set speed will continue to decrease until the lever is

162 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 501 502

Comments to this Manuals

No comments

Dodge 2012 Caliber Owner's Manual Page 164

Comments to this Manuals

Related products and manuals for Cars Dodge 2012 Caliber