Dodge 2013 Challenger_SRT - User Guide User Manual download pdf (Page 20)

•Attachthelowerhooksorconnectorsoverthetopoftheanchoragebars,pushingaside

the seat cover material. The rear seat lower anchorages are round bars, located at the

rear of the seat cushion where it meets the seatback. The rear seat lower anchors can be

readily identified by the symbol

located on the seatback directly above the anchor-

ages and are just visible when you lean into the rear seat to install the child restraint.

• Then rotate the tether anchorage cover directly behind the seat where you are placing the

child restraint and attach the tether strap to the anchorage, being careful to route the

tether strap to provide the most direct path between the anchor and the child restraint.

• Tighten all three straps as you push the

child restraint rearward and downward

into the seat.

Installing The Child Restraint Using The Vehicle Seat Belts

•Toinstallachildrestraint,first,pullenoughoftheseatbeltwebbingfromtheretractorto

route it through the belt path of the child restraint and slide the latch plate into the

buckle.

•Next,extractalltheseatbeltwebbingoutoftheretractorandthenallowthebeltto

retract into the retractor. Finally, pull on any excess webbing to tighten the lap portion

around the child restraint. Any seat belt system will loosen with time, so check the belt

occasionally, and pull it tight if necessary.

• Rotate the cover over the anchor directly behind the seat where you are placing the child

restraint. These tether strap anchorages are under a plastic cover.

•Routethetetherstraptoprovidethemostdirectpathforthestrapbetweentheanchor

and the child seat.

•Attachthetetherstraphookofthechildrestrainttotheanchorandremoveslackinthe

tether strap according to the child restraint manufacturer’s instructions.

GETTING STARTED

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 139 140

No comments

Dodge 2013 Challenger_SRT - User Guide User Manual Page 20