Dodge 2013 Challenger_SRT - User Guide User Manual download pdf (Page 76)

Programming A Rolling Code

•

For programming Garage Door Openers that were manufactured after 1995. These Garage

Door Openers can be identified by the “LEARN” or “TRAIN” button located where the hanging

antenna is attached to the Garage Door Opener. It is NOT the button that is normally used to

open and close the door. The name and color of the button may vary by manufacturer.

1. Place the ignition switch into the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you

wish to program while keeping the HomeLink® indicator light in view.

3. Simultaneously press and hold both the Homelink® button you want to program and the

hand-held transmitter button.

4. Continue to hold buttons until the EVIC display changes from “CHANNEL # TRAINING” to

“CHANNEL # TRAINED”, then release both buttons.

NOTE:

If the EVIC displays “DID NOT TRAIN” repeat from Step 2.

5. At the garage door opener motor (in the garage), locate the “LEARN” or “TRAINING”

button. This can usually be found where the hanging antenna wire is attached to the

garage door opener motor. Firmly press and release the “LEARN” or “TRAINING” button.

NOTE:

You have 30 seconds in which to initiate the next step after the LEARN button has been

pressed.

6. Return to the vehicle and press the programmed HomeLink® button twice (holding the

button for two seconds each time). The EVIC will display “CHANNEL # TRANSMIT”. If the

garage door opener/device activates, programming is complete.

NOTE:

If the device does not activate, press the button a third time (for two seconds) to complete

the training.

7. To program the remaining two HomeLink® buttons, repeat each step for each remaining

button. DO NOT erase the channels.

Programming A Non-Rolling Code

•ForprogrammingGarageDoorOpenersmanufacturedbefore1995.

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you

wish to program while keeping the HomeLink® indicator light in view.

3. Simultaneously press and hold both the HomeLink® button you want to program and the

hand-held transmitter button.

4. Continue to hold buttons until the EVIC display changes from “CHANNEL # TRAINING” to

“CHANNEL # TRAINED”, then release both buttons.

5. Press and hold the programmed HomeLink® button and observe the indicator light.

ELECTRONICS

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 139 140

No comments

Dodge 2013 Challenger_SRT - User Guide User Manual Page 76