Dodge 2013 Challenger_SRT - User Guide User Manual download pdf (Page 100)

• If the sealant (white fluid) does flow through the Sealant Hose (6):

1. Continue to operate the pump until sealant is no longer flowing through the hose

(typically takes 30 - 70 seconds). As the sealant flows through the Sealant Hose (6),

the Pressure Gauge (3) can read as high as 70 psi (5 kPa). The Pressure Gauge (3) will

decrease quickly from approximately 70 psi (5 kPa) to the actual tire pressure when

the Sealant Bottle (1) is empty.

2. The pump will start to inject air into the tire immediately after the Sealant Bottle (1)

is empty. Continue to operate the pump and inflate the tire to the pressure indicated

on the tire pressure label on the driver-side latch pillar (recommended pressure).

Check the tire pressure by looking at the Pressure Gauge (3).

• If the tire does not inflate to at least 26 psi (1.8 kPa) pressure within 15 minutes:

•Thetireistoobadlydamaged.Donotattempttodrivethevehiclefurther.Callfor

assistance.

NOTE:

If the tire becomes over-inflated, press the Deflation Button to reduce the tire pressure to

the recommended inflation pressure before continuing.

• If the tire inflates to the recommended pressure or is at least 26 psi (1.8 Bar) pressure

within 15 minutes:

1. Press the Power Button (4) to turn off the TIREFIT kit.

2. Remove the Speed Limit sticker from the top of the Sealant Bottle (1) and place the

sticker on the instrument panel.

3. Immediately disconnect the Sealant Hose (6) from the valve stem, reinstall the cap

on the fitting at the end of the hose, and place the TIREFIT kit in the vehicle storage

location. Quickly proceed to (D) “Drive Vehicle”.

(D) Drive Vehicle:

• Immediately after injecting sealant and inflating the tire, drive the vehicle 5 miles (8 km)

or 10 minutes to ensure distribution of the TIREFIT Sealant within the tire. Do not exceed

55 mph (88 km/h).

(E) After Driving:

•Pullovertoasafelocation.Referto“WheneverYouStoptoUseTIREFIT”before

continuing.

1. Turn the Mode Select Knob (5) to the Air Mode position.

2. Uncoil the Air Pump Hose (7) (black in color) and screw the fitting at the end of hose (7)

onto the valve stem.

3. Uncoil the power plug and insert the plug into the vehicles 12 Volt power outlet.

4. Check the pressure in the tire by reading the Pressure Gauge (3).

WHAT TO DO IN EMERGENCIES

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 139 140

No comments

Dodge 2013 Challenger_SRT - User Guide User Manual Page 100