Dodge 2013 Challenger_SRT - User Guide User Manual download pdf (Page 16)

THEFT ALARM

To Arm

• Keyless Enter-N-Go™ button installed: Press the Keyless Enter-N-Go™ Start/Stop but-

ton until the Electronic Vehicle Information Center (EVIC) indicates that the vehicle

ignition is “OFF”. Press the power door lock switch while the door is open, press the Key

Fob LOCK button, or with one of the Key Fobs located outside the vehicle and within 5 ft

(1.5 m) of the driver's and passenger front door handles, press the Keyless Enter-N-Go™

LOCK button located on the door handle.

• Keyless Enter-N-Go™ button not installed: Tu rn the ignition switch to the “ OFF ” posi-

tion. Press the power door lock switch while the door is open, press the Key Fob LOCK

button, or with one of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of

the driver's and passenger front door handles, press the Keyless Enter-N-Go™ LOCK

button located on the door handle.

NOTE:

After pressing the Keyless Enter-N-Go™ LOCK button, you must wait two seconds before

you can lock or unlock the vehicle via the door handle.

To Disarm

• Keyless Enter-N-Go™ button installed: Press the Key Fob UNLOCK button or with one of

the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and

passenger front door handles, grab the Keyless Enter-N-Go™ door handle and enter the

vehicle, then press the Keyless Enter-N-Go™ Start/Stop button (requires at least one

valid Key Fob in the vehicle).

• Keyless Enter-N-Go™ button not installed: Press the Key Fob UNLOCK button or with

one of the Key Fobs located outside the vehicle and within 5 ft (1.5 m) of the driver's and

passenger front door handles, grab the Keyless Enter-N-Go™ door handle and enter the

vehicle, then turn the ignition to the ON/RUN position.

GETTING STARTED

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 139 140

No comments

Dodge 2013 Challenger_SRT - User Guide User Manual Page 16