Dodge JR41 User Manual download pdf (Page 72)

3. Choose one of the three Universal Transceiver buttons

to program. Place the hand held controller one to three

inches from the Universal Transceiver while keeping its

indicator light in view.

4. Using both hands, press the hand held transmitter

button and the desired Universal Transceiver button. Do

not release the buttons until step 5 has been completed.

NOTE:

Some entry gates and garage door openers may

require you to replace step 4 with the procedures listed

under Canadian Programming.

5. The indicator light in the Universal Transceiver will

begin to flash, first slowly and then rapidly. The rapid

flashing indicates successful programming. If after 90

seconds the indicator light does not flash rapidly or goes

out, returnto step1 and repeatthe procedure. To trainthe

other buttons, repeat steps 3 and 4. Be sure to keep your

hand held transmitters in case you need to retrain the

Universal Transceiver.

NOTE:

If you do not successfully program the

Universal Transceiver to learn the signal of your hand

held transmitter, refer tothe Rolling Code Paragraph, or

call toll free for customer assistance at 1–800–355–3515,

or on the internet at www.homelink.com.

“Rolling Code” Programming

NOTE:

If your hand held transmitter appears to pro-

gram the Universal Transceiver, but your garage door or

other device does not operate, and your device was

manufactured after 1996, your garage door opener or

other device may have a “Rolling Code” system.

72 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 272 273

No comments

Dodge JR41 User Manual Page 72