Dodge 2013 Charger User Manual download pdf (Page 394)

100

101

4. If you wish to stop the cranking of the engine prior to

the engine starting, press the button again.

NOTE: Normal starting of either a cold or a warm

engine is obtained without pumping or pressing the

accelerator pedal.

To Turn Off The Engine Using ENGINE

START/STOP Button

1. Place the shift lever in PARK, then press and release

the ENGINE START/STOP button.

2. The ignition switch will return to the OFF position.

3. If the shift lever is not in PARK, the ENGINE START/

STOP button must be held for two seconds and vehicle

speed must be below 5 mph (8 km/h) before the

engine will shut off. The ignition switch position will

remain in the ACC position until the shift lever is in

PARK and the button is pressed twice to the OFF

position. If the shift lever is not in PARK and the

ENGINE START/STOP button is pressed once, the

EVIC (if equipped) will display a “Vehicle Not In

Park” message and the engine will remain running.

Never leave a vehicle out of the PARK position, or it

could roll.

NOTE: If the ignition switch is left in the ACC or RUN

(engine not running) position and the transmission is in

PARK, the system will automatically time out after 30

minutes of inactivity and the ignition will switch to the

OFF position.

ENGINE START/STOP Button Functions – With

Driver’s Foot OFF The Brake Pedal (In PARK Or

NEUTRAL Position)

The ENGINE START/STOP button operates similar to an

ignition switch. It has four positions, OFF, ACC, RUN

and START. To change the ignition switch positions

without starting the vehicle and use the accessories

follow these steps.

392 STARTING AND OPERATING

1 2 ... 389 390 391 392 393 394 395 396 397 398 399 ... 621 622

Comments to this Manuals

No comments

Dodge 2013 Charger User Manual Page 394

Comments to this Manuals

Related products and manuals for Cars Dodge 2013 Charger