Dodge 2014 Charger - User Guide User Manual download pdf (Page 94)

NOTE:

If the vehicle is too low for jack placement, slide the jack on its side and rotate it up into

position.

5. Raise the vehicle just enough to remove

the flat tire and install the spare tire.

6. Remove the lug nuts and tire.

7. Mount the spare tire.

NOTE:

• For vehicles so equipped, do not at-

tempt to install a center cap or wheel

cover on the compact spare.

• Refer to “Compact Spare Tire” and to

“Limited-Use Spare” under “Tires—

General Information” in “Starting and

Operating” in the Owner's Manual on

the DVD for additional warnings, cau-

tions, and information about the spare

tire, its use, and operation.

8. Install the lug nuts with the cone shaped

end of the lug nut toward the wheel.

Lightly tighten the lug nuts.

9. Lower the vehicle to the ground by turn-

ing the jack handle counterclockwise.

10. Finish tightening the lug nuts. Push

down on the wrench while at the end of

the handle for increased leverage.

Tighten the lug nuts in a star pattern

until each nut has been tightened twice.

The correct tightness of each lug nut is

130 ft-lb. (176 N·m). If in doubt about the

correct tightness, have them checked

with a torque wrench by your authorized

dealer or at a service station.

11. Stow the jack, tools and flat tire. Make

sure the base of the jack faces the front

of the vehicle before tightening down the

fastener.

WHAT TO DO IN EMERGENCIES

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 147 148

No comments

Dodge 2014 Charger - User Guide User Manual Page 94