Dodge 2014 Charger - User Guide User Manual download pdf (Page 100)

If the tire inflates to the recommended pressure or is at least 26 psi (1.8 Bar) pressure

within 15 minutes:

1. Press the Power Button (4) to turn off the TIREFIT kit.

2. Remove the Speed Limit sticker from the top of the Sealant Bottle (1) and place the

sticker on the instrument panel.

3. Immediately disconnect the Sealant Hose (6) from the valve stem, reinstall the cap on

the fitting at the end of the hose, and place the TIREFIT kit in the vehicle storage

location. Quickly proceed to (D) “Drive Vehicle.”

(D) Drive Vehicle:

Immediately after injecting sealant and inflating the tire, drive the vehicle 5 miles (8 km) or

10 minutes to ensure distribution of the TIREFIT Sealant within the tire. Do not exceed

55 mph (88 km/h).

(E) After Driving:

Pull over to a safe location. Refer to “Whenever You Stop to Use TIREFIT” before continuing.

1. Turn the Mode Select Knob (5) to the Air Mode position.

2. Uncoil the Air Pump Hose (7) (black in color) and screw the fitting at the end of hose (7)

onto the valve stem.

3. Uncoil the power plug and insert the plug into the vehicles 12 Volt power outlet.

4. Check the pressure in the tire by reading the Pressure Gauge (3).

If tire pressure is less than 19 psi (1.3 Bar), the tire is too badly damaged. Do not attempt

to drive the vehicle further. Call for assistance.

If the tire pressure is 19 psi (1.3 Bar) or higher:

1. Press the Power Button (4) to turn on TIREFIT and inflate the tire to the pressure indicated

on the tire and loading information label on the driver-side door opening.

2. Disconnect the TIREFIT kit from the valve stem, reinstall the cap on the valve stem and

unplug from 12 Volt outlet.

3. Place the TIREFIT kit in its proper storage area in the vehicle.

4. Have the tire inspected and repaired or replaced at the earliest opportunity at an

authorized dealer or tire service center.

5. Replace the Sealant Bottle (1) and Sealant Hose (6) assembly at your authorized dealer

as soon as possible. Refer to “(F) Sealant Bottle and Hose Replacement.”

NOTE:

• If the tire becomes over-inflated, press the Deflation Button to reduce the tire pressure to

the recommended inflation pressure before continuing.

• When having the tire serviced, advise the authorized dealer or service center that the tire

has been sealed using the TIREFIT service kit.

WHAT TO DO IN EMERGENCIES

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 147 148

No comments

Dodge 2014 Charger - User Guide User Manual Page 100