Dodge 2014 Charger - User Guide User Manual download pdf (Page 101)

(F) Sealant Bottle And Hose Replacement:

1. Uncoil the Sealant Hose (6) (clear in color).

2. Locate the round Sealant Bottle release button in the recessed area under the sealant

bottle.

3. Press the Sealant Bottle release button. The Sealant Bottle (1) will pop up. Remove the

bottle and dispose of it accordingly.

4. Clean any remaining sealant from the TIREFIT housing.

5. Position the new Sealant Bottle (1) in the housing so that the Sealant Hose (6) aligns with

the hose slot in the front of the housing. Press the bottle into the housing. An audible

click will be heard indicating the bottle is locked into place.

6. Verify that the cap is installed on the fitting at the end of the Sealant Hose (6) and return

the hose to its storage area (located on the bottom of the air pump).

7. Return the TIREFIT kit to its storage location in the vehicle.

CAUTION!

• The metal end fitting from Power Plug (8) may get hot after use, so it should be

handled carefully.

• Failure to reinstall the cap on the fitting at the end of the Sealant Hose (6) can result

in sealant contacting your skin, clothing, and the vehicle’s interior. It can also result in

sealant contacting internal TIREFIT kit components which may cause permanent

damage to the kit.

WHAT TO DO IN EMERGENCIES

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 147 148

No comments

Dodge 2014 Charger - User Guide User Manual Page 101