Sound Horn With Lock
• To turn the horn chirp on or off when the doors are locked:
• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds.
Then, press the PANIC button while still holding the LOCK button.
• Release both buttons at the same time.
Flash Lamps With Lock
• The turn signal lights flashing feature, when the doors are locked or unlocked,
can be turned on or off. To turn this feature on or off:
• Press and hold the UNLOCK button for at least 4 seconds, but no longer than
10 seconds. Then, press and hold the LOCK button while still holding the
UNLOCK button.
• Release both buttons at the same time.
UNIVERSAL GARAGE DOOR OPENER (HomeLink
®
)
• HomeLink
®
replaces up to three hand-held transmitters that operate devices
such as garage door openers, motorized gates, lighting or home security
systems. The HomeLink
®
unit is powered by your vehicles 12 Volt battery.
• The HomeLink
®
buttons that are located in the overhead console or sunvisor
designate the three different HomeLink
®
channels.
• The HomeLink
®
indicator is located above the center button.
Before You Begin Programming
HomeLink
®
• Be sure that your vehicle is parked
outside of the garage before you
begin programming.
• For more efficient programming and
accurate transmission of the
radio-frequency signal it is
recommended that a new battery be
placed in the hand-held transmitter
of the device that is being
programmed to the HomeLink
®
system.
• Erase all channels before you begin programming. To erase the channels,
place the ignition switch into the ON/RUN position, then press and hold the
two outside HomeLink
®
buttons (I and III) for up 20 seconds or until the red
indicator flashes.
NOTE:
• Erasing all channels should only be performed when programming HomeLink
®
for the first time. Do not erase channels when programming additional buttons.
ELECTRONICS
69
Comments to this Manuals