Dodge 2010 Nitro Owner's Manual Page 161

  • Download
  • Add to my manuals
  • Print
  • Page
    / 488
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 160
After training a HomeLink channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to the heading “Programming A Rolling Code
System.”
4. Press and hold the just-trained HomeLink button
and observe the indicator light.
If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink button is pressed.
If the indicator light blinks rapidly for two seconds, and
then turns to a constant light, continue with program-
ming for a Rolling Code.
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “Learn” or “Training” button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open and close the
door).
1 Garage Door Opener
2 Training Button
160 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page view 160
1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 487 488

Comments to this Manuals

No comments