Dodge Ram Power Wagon Operations Instructions download pdf (Page 145)

100

101

2. Position the end of your hand-held transmitter 1-3

inches (3-8 cm) away from the HomeLink buttons while

keeping the indicator light in view.

3. Simultaneously press and hold both the HomeLink

button that you want to train and the hand-held trans-

mitter buttons. Do not release the buttons until step 4

has been completed.

NOTE: Some gate operators and garage door openers

may require you to replace this Programming Step 3 with

procedures noted in the ⬙Gate Operator/Canadian Pro-

gramming⬙ section.

4. The HomeLink indicator light will flash slowly and

then rapidly after HomeLink successfully receives the

frequency signal from the hand-held transmitter. Release

both buttons after the indicator light changes from the

slow to the rapid flash.

5. Press and hold the just trained HomeLink button and

observe the indicator light. If the indicator light stays on

constantly, programming is complete and your device

should activate when the HomeLink button is pressed

and released.

NOTE: To program the remaining two HomeLink but-

tons, begin with ⬙Programming⬙ step two. Do not repeat

step one.

If the indicator light blinks rapidly for two seconds and

then turns to a constant light, continue with ⴖProgram-

mingⴖ steps 6-8 to complete the programming of a rolling

code equipped device (most commonly a garage door

opener).

6. At the garage door opener receiver (motor-head unit)

in the garage, locate the ⬙learn⬙ or ⬙smart⬙ button. This

can usually be found where the hanging antenna wire is

attached to the motor-head unit.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 466 467

Comments to this Manuals

No comments

Dodge Ram Power Wagon Operations Instructions Page 145

Comments to this Manuals

Related products and manuals for Cars Dodge Ram Power Wagon