Dodge 2008 Charger User Manual download pdf (Page 144)

100

101

Then proceed with Step 4 under “Programming

HomeLink.” earlier in this section.

Using HomeLinkT

To operate, simply press and release the programmed

HomeLinkt button. Activation will now occur for the

trained device (i.e. garage door opener, gate operator,

security system, entry door lock, home/office lighting,

etc. The hand-held transmitter of the device may also be

used at any time.

Reprogramming a Single HomeLinkT Button

To re-program a channel that has been previously

trained, follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLinkt button for 20

seconds until the EVIC display states “CHANNEL #

TRAINING.” Do not release the button.

3. Without releasing the button, proceed with PRO-

GRAMMING HOMELINK Step#2 andfollow all remain-

ing steps.

Security

It is advised to erase all channels before you sell or turn

in your vehicle.

To do this, press and hold the two outside buttons for 20

seconds until the EVIC message states “CHANNELS

CLEARED.” Note that all channels will be erased. Indi-

vidual channels cannot be erased.

The HomeLinkt Universal Transceiver is disabled when

the Vehicle Security Alarm is active.

144 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 465 466

Comments to this Manuals

No comments

Dodge 2008 Charger User Manual Page 144

Comments to this Manuals

Related products and manuals for Cars Dodge 2008 Charger